I am getting the same error as on a few other posts.
I have tried the things discussed but found no solution.

- Using a VIA motherboard
- Created an XPe image that boots OK from HD
Use XP Pro install for TAP etc

- Now Creating a HORM image

- During FBA I get a message:
The instruction at "0x030ee132" referenced memory at
"0x0000000C". The memory could not be "written".

- Using 2G HD partition, 512M RAM, image size about 480M
Boot rdisk(0) Partition 1
I have a 2nd partition on thatdisk
- XP Pro HD removed from system

Q Is there something special about memory location 0X0000000C given that
this appears to be the source of similar errors with others?
Q Any further things to try. I guess its something in my project config?

Target set at partition C:\ etc, size 1024, Cluster 4096

Using XPE SP2 (Not FP2007)

David Jones
Software Developer
(Embeddded Systems)
Victorian Partnership of Advanced Computing
Melbourne, Victoria Australia

Solved this about 20 minutes after posting.
Case of check and recheck everything.

I have 2 partitions on the drive.
The first contains the image for FBA
The 2nd contains a copy of the previous bootable XPe image post FBA

Turns out the2nd was marked as Active

>>>>>>>>>>Fix was to mark the first partition as the active one! <<<<<<<<<<<<<

Comment
So I guess the the FBA was accessing some in the first partition, some in
second and getting confused along the way. There was a hint offered that I
chose to ignore .. Doh! .. in that when I looked at the file system D drive
was showing.
--
David Jones
Software Developer
(Embeddded Systems)
Victorian Partnership of Advanced Computing
Melbourne, Victoria Australia


"David Jones" wrote:

> I am getting the same error as on a few other posts.
> I have tried the things discussed but found no solution.
>
> - Using a VIA motherboard
> - Created an XPe image that boots OK from HD
> Use XP Pro install for TAP etc
>
> - Now Creating a HORM image
>
> - During FBA I get a message:
> The instruction at "0x030ee132" referenced memory at
> "0x0000000C". The memory could not be "written".
>
> - Using 2G HD partition, 512M RAM, image size about 480M
> Boot rdisk(0) Partition 1
> I have a 2nd partition on thatdisk
> - XP Pro HD removed from system
>
> Q Is there something special about memory location 0X0000000C given that
> this appears to be the source of similar errors with others?
> Q Any further things to try. I guess its something in my project config?
>
> Target set at partition C:\ etc, size 1024, Cluster 4096
>
> Using XPE SP2 (Not FP2007)
>
> David Jones
> Software Developer
> (Embeddded Systems)
> Victorian Partnership of Advanced Computing
> Melbourne, Victoria Australia